Lanex PB-20 Instruction Manual

CONTENT OF BELT IDENTITY LABEL
PB-20
WORK POSITIONING BELT
Ref. XPPB20MXL
EN 358:200
IT IS THE RESPONSIBILITY OF THE USER ORGANISATION TO PROVIDE THE IDENTITY CARD AND TO FILL IN THE DETAILS REQUIRED.
THE IDENTITY CARD SHOULD BE FILLED IN BEFORE THE FIRST USE BY A COMPETENT PERSON, RESPONSIBLE INTHE USER ORGANIZATION FOR PROTECTIVE EQUIPMENT.
ANY INFORMATION ABOUT THE EQUIPMENT LIKE PERIODIC INSPECTIONS, REPAIRS, REASONS OF EQUIPMENT'S WITHDRAWN FROM USE SHALL BE NOTED INTO THE IDENTITY CARD BY A COMPETENT PERSON.
THE IDENTITY CARD SHOULD BE STORAGED DURING A WHOLE PERIOD OF EQUIPMENT UTILIZATION.
DO NOT USE THE EQUIPMENT WITHOUT THE IDENTITY CARD.
ALL RECORDS IN THE IDENTITY CARD CAN BE FILLED IN ONLY BY A COMPETENT PERSON.
IDENTITY CARD
MODEL AND TYPE OF EQUIPMENT
REF. NUMBER
SERIAL NUMBER
USER NAME
DATE OF PURCHASE
PERIODIC EXAMINATION AND REPAIR HISTORY
REASON FOR
DATE
ENTRY PERIODIC EXAMINATION
OR REPAIR AND OTHER REVELANT INFORMATIONS
1
2
3
4
Hlučínská 1 / 96, 747 23 Bolatice, Tel: + 420 553 751 111, Fax:: + 420 553 654 125
Size: M-XL
XXL
Date
of manufacture: 03/2003
Serial
number: 0000001
DATE OF MANUF.
DATE OF PUTTING INTO OPERATION
DEFECTS NOTED, NAME AND SIGNATURE
REPAIRS CARRIED OUT OF COMPETENT PERSON
e-mail: lanex@lanex.cz, www.lanex.cz
Instruction Manual
Ref. XPPB20MXL
EN 358:2000
The work positioning belt is the component of the personal protective equipment for work positioning and prevention of falls from a
height. The belt complies with EN 358.
The function of the belt is to prevent an occurrence of a fall from the height.
DESCRIPTION
The work positioning belt is made of one piece of polyamide webbing which is suitable sewn and connected by metal buckle.
This configuration guarantee full safety and comfort work.
BASIC EQUIPMENT
front connecting and adjusting buckle - for comfort wearing and using of the belt
!
side attaching buckles - for attaching work positioning system
!
belt pad - suitably formed, ergonomic, made of special foam
!
small plastic "D" rings - for attaching tool bags
!
SIZES
The belt is manufactured in two sizes:
- universal: M-XL
- extra large: XXL
Periodic inspections
The device must be inspected at least once every 12 months from the date of first use. Periodic inspections must only be carried out by a
competent person who has the knowledge and training required for personal protective equipment periodic inspections.Depending
upon the type and environment of work, inspections may be needed to be carried out more frequently than once every 12 months.
PERIODIC
EXAMINATION
NEXT DUE DATE
Maximum lifetime of the device
The maximum lifetime of the device is 8 years from the date of manufacture. The maximum lifetime depends on the intensity of usage and
the environment of usage. Using the device in rough environment, marine environment, contact with sharp edges, exposure to extreme
temperatures or agressive substances, etc. can lead to the wthdrawal from use even after one use.The device must be withdrawn from
use immediately and destroyed when it has been used to arrest a fall
WORK POSITIONING BELT PB-20
side buckles
for attaching
work positioning
system
belt pad
connecting
identity label
and adjusting
buckle
small "D" rings
for attaching
tool bags
EC type examination carried out by
CETE APAVE SUDEUROPE
BP 193, 13322 Marseille
France - 0082