Table of Contents
Advertisement
9. Hold the barrel at approximately 60° (+ or -20°) angle, rest the tip on a piece of paper and
dispense a small amount of material. This initial dispensing will fill the tip with material.
10. Depress the foot pedal to dispense material.
11. Place barrel in Dispenser Cubby when dispensing operation is
complete.
NOTE: Condensation may occur in the air hose after extended
use.
This is a normal occurrence.
condensation, disconnect the air hose from the barrel adapter and actuate the dispense
pump. The air pressure will blow the condensation from the air hose.
Adjustment of Dispensing Modes
The Mode Switch is located on the rear panel of the unit. Please refer to the table below for the
settings.
NOTE: Dispensing at controlled time means dispensing according to set dispensing and interval
times.
ON
1
2
3
4
Item
Mode Switch Status
No.
S1
S2
1
OFF
OFF
2
ON
OFF
3
OFF
ON
4
ON
ON
5
OFF
OFF
6
ON
OFF
7
OFF
ON
8
ON
ON
9
OFF
OFF
10
ON
OFF
11
OFF
ON
12
ON
ON
13
OFF
OFF
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Function
S3
S4
With pedal switch pressed, dispense continuously,
OFF
OFF
otherwise it will stop dispensing.
OFF
OFF
Be triggered once, dispense at controlled time once.
OFF
OFF
Be triggered once, dispense at controlled time twice.
Be triggered once, dispense at controlled time three
OFF
OFF
times.
Be triggered once, dispense at controlled time four
ON
OFF
times.
ON
OFF
Be triggered once, dispense at controlled time five times.
ON
OFF
Be triggered once, dispense at controlled time six times.
Be triggered once, dispense at controlled time seven
ON
OFF
times.
Be triggered once, dispense at controlled time eight
OFF
ON
times.
Be triggered once, dispense at controlled time nine
OFF
ON
times.
OFF
ON
Be triggered once, dispense at controlled time ten times.
Be triggered once, dispense at controlled time eleven
OFF
ON
times.
Be triggered once, dispense at controlled time twelve
ON
ON
times.
To remove the
Page 8 of 15
Advertisement
Table of Contents
