Safety Instructions And Measures - Samson 44-7 Mounting And Operating Instructions

Safety instructions and measures

1. Safety instructions and measures
Intended use
The SAMSON Type 44-4 and Type 44-7 Pressure Regulators are suitable for pressure control
of liquids and gases. The regulators are designed to operate under exactly defined
conditions (e.g. operating pressure, process medium, temperature). Therefore, operators must
ensure that the regulators are only used in operating conditions that meet the specifications
used for sizing the devices at the ordering stage. In case operators intend to use the
regulators in applications or conditions other than those specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the
device for its intended purpose or for damage caused by external forces or any other
external factors.
Î Refer to the technical data and nameplate for limits and fields of application as well as
possible uses.
Reasonably foreseeable misuse
The regulators are not suitable for the following applications:
− Use outside the limits defined during sizing and by the technical data
− Use outside the limits defined by the accessories mounted on the regulator
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described
− Modification of parts as well as service or repair work on the TÜV-tested Type 44-4
Qualifications of operating personnel
The regulator must be mounted, started up, serviced and repaired by fully trained and quali-
fied personnel only; the accepted industry codes and practices must be observed. According
to these mounting and operating instructions, trained personnel refers to individuals who are
able to judge the work they are assigned to and recognize possible hazards due to their spe-
cialized training, their knowledge and experience as well as their knowledge of the applica-
ble standards.
EB 2723 EN 5