Table of Contents
Advertisement
1. Check mains gas is ON.
2. Check pressure at pressure test point to ensure gas is flowing to the appliance.
3. If gas is present then check burner injector for blockage.
4. If injector is clear then check FFD magnet unit is engaging and allowing gas to pass.
5. OVEN ONLY - Check for spark at spark electrode.
6. OVEN ONLY - if there is no spark then check spark gap and igniter lead connections.
Also check igniter and earth lead connections (if fitted).
7. If a flame is still not present then re-check from start.
If a flame is established but not maintained then follow this check list:
1. Check thermocouple sensor is secured correctly and that burner ports are clean.
2. Check that thermocouple is not damaged and is securely fixed to FFD section of gas
control.
3. Check FFD is energising and maintaining flame.
4. If after carrying out the above, the burner is still not maintaining the flame then check
magnet unit within control.
SECTION 4 - SPARES
When ordering spare parts, always quote the appliance type and serial number.
This information will be found on the data badge attached on the rear of the product.
Advertisement
Table of Contents
