Table of Contents
Advertisement
3. Remove the two screws at each end of the fascia panel.
4. Lastly remove the 3 fixing screws from the front of the fascia panel.
5. Fascia panel can now be removed from the appliance.
3.1.2 Removal of the hotplate
1. Remove all pan supports, burner caps and burner skirts.
2. Using the front left hand and right hand burner apertures lift the front of the hotplate
upwards to an angle of approximately 45° and then pull the hotplate forward.
3. The hotplate should now be free from the rear vent and can be removed from the
appliance.
3.1.3 Replacement of hotplate burner (jet holder)
1. Remove hotplate as detailed on the previous page.
2. Disconnect the hotplate pipe from the chosen burner by undoing the compression nut
at the burner.
3. Remove the two fixing screws holding the hotplate burner in place.
4. The burner can now be removed from the appliance.
5. The new hotplate burner is to be fitted in the reverse order.
3.1.4 Replacement of the oven burner
1. Remove oven shelves, and oven base panel.
2. Disconnect the oven burner pipe from the brass injector on the oven burner.
3. Disconnect the thermocouple from the oven burner.
4. Disconnect the electrode lead from the oven electrode.
5. Remove the four screws from the oven burner (note that the electrode bracket will also
become free from the appliance by removing the burner fixing screws).
6. The oven burner can now be replaced.
7. To fit new oven burner the above sequence should be followed in reverse.
3.1.5 Cleaning
Burners should be cleaned periodically to maintain maximum performance.
Open top burners should be cleaned as detailed in User Instructions.
Other burners are best cleaned with a wire brush; port blockage should be cleared using a
metal broach, any loose material being shaken out via the burner shank.
3.2 INJECTORS
3.2.1 Hotplate
1. Remove burner caps and skirts.
2. Undo and carefully remove injector.
3. Replace in reverse order.
3.2.2 Oven
1. Remove burner as detailed in 'Replacement of the oven burner'.
2. Undo injector and remove.
3. Replace in reverse order.
3.3 THERMOCOUPLES AND FLAME FAILURE DEVICE (FFD)
3.3.1 Hotplate flame failure device magnet unit
1. Undo thermocouple at FFD section of gas tap.
2. Undo FFD section cap at rear of gas tap and withdraw magnet unit and replace in
reverse order.
3.3.2 Hotplate thermocouple
1. Remove hotplate as detailed in Section 3.1.2.
2. Remove nut securing thermocouple sensor to burner support bracket and pull
thermocouple through support bracket from underside.
3. Undo thermocouple connection at FFD section of gas tap and carefully remove
thermocouple.
4. Replace in reverse order, take care not to overtighten thermocouple.
3.3.3 Oven flame failure device magnet unit
Advertisement
Table of Contents
