General Troubleshooting; Figure 21 : Selecting Usb Device Corresponding To Application Board - Bosch BMI090L User Manual

Bosch Sensortec | BMI090L User Manual

5. General Troubleshooting

Follow below guidelines while working with DD2.0 UI:
 Ensure that the shuttle board (with a valid sensor) is seated properly in the application board.
 Ensure that the PC-board connection is properly established.
 When switching on/ off DD2.0 UI, close and restart DD2.0 UI.
 Ensure that at least one channel is selected.
Follow these steps to check the USB connection:
1. Click My Computer -> Manage -> Computer Management.
2. Go to System Tools -> Device Manager.
3. Click on BST board and check for the USB connection.
Sometimes, data transfer between PC and application board does not work despite the USB device being
properly enumerated in the Device Manager.
This could be because the application board is older or that the USB PID and VID has been used with
that computer before. In this case, Windows is unable to install the required drivers automatically.
Follow these steps to check the USB connection:
1. Right-click on the USB-device corresponding to your application board (if you are not sure which
device corresponds to your application Board, unplug all other USB devices like keyboard and mouse
temporarily).

Figure 21 : Selecting USB device corresponding to application board

2. Click Action -> Scan for hardware changes. The new USB driver installed automatically.
Thereafter, the device communication will function properly.
Modifications reserved | Data subject to change without notice
19 | 24
Document number: BST-DHW-SD024-00