Then when the vistor calls the tenant,the system will switch the 1 Door phone sign and function explanation: call to Guard Center, Guard Center tells the message to the vistor, Function explanation Sign until the tenant calls Guard Center to cancel divert on. Call Control Center ⑤.The tenant could press“...
Page 3
continue flashing(slowly) after 100s(The tenant must leave and close block,or it will alarm all the time.The pin with connecting alarm sensor should be unplugged short block,or can not deal with the alarm in time. door and windows in 100s before enter arm status ,or it will cause IR Among the alarm sensors,some of them are open circuit alarm NC alarm and door contact alarm).
Page 4
can be heard twice,it means modify successfully,or long tone can be heard, 2> . When sensor loop is forced to short circuit or open circuit, it means failing to modify, needs starting again. door phone will start beeping and send the alarm to Control Center. b.If forgeting password of door phone, the tenant could restore originalpassword“12341234”.
Page 5
9 Muted(Anti-disturb)setting: ⑤If the system contain Guard Station,door phone can not be diverted on; ①.Under standby and unarmed status,press“4”,then press" ", when door phone call Control Center ,it will call to Guard Station,when release two keys at the same time,finished setting after“Di Di”can be heard door phone alarms,it will send the alarm to Guard Station and Guard Center twice.When the visitors call ,door phone will be quiet, anti-disturb function at the same time.
Need help?
Do you have a question about the Elite Series and is the answer not in the manual?
Questions and answers