U.k. Wiring Instructions - Nova 110201 Manual

• Place the appliance on a heat­resistant and
splash­proof surface.
• Do not place the appliance on a hob.
• Do not cover the appliance.
• Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
• Make sure that the appliance does not
come into contact with flammable material.
• Keep the appliance away from heat
sources. Do not place the appliance on hot
surfaces or near open flames.
• Beware of steam and splashes when
putting food on the hot baking plates.
• Caution: Hot grease can splash from the
baking plates.
• Do not pour cold water onto the hot
baking plates. The water will splash and
damage the baking plates.
• Always be careful when touching the
appliance. Use oven gloves if you need to
touch the appliance during or shortly after
use.
• Beware of hot parts. The surfaces marked
with a caution symbol for hot surfaces are
liable to become hot during use. The
accessible surfaces can become hot when
the appliance is operating. The outer
surface can become hot when the
appliance is operating.
• The baking plates become very hot during
use. Do not touch the hot baking plates.
• Make sure that your hands are dry before
touching the appliance.
• Do not leave the appliance unattended
during use.
• Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
• Do not use the appliance near birds (e.g.
tropical birds such as parrots). The baking
plates are finished with a non­stick coating
based on PTFE. Upon heating, the coating
may release small amounts of gases which
are fully harmless for people. However, the
nervous systems of birds are extremely
sensitive to these gases.

U.K. Wiring instructions

The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
EARTH
GREEN/YELLOW
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (earth symbol)
and is coloured GREEN or GREEN/YELLOW.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
Disclaimer
Subject to change; specifications can be
changed without further notice.
14