Firmware And System Menu; Creating An Edc File; Description Of The Iop File Of The System Menu; Fig. 7 Jetter Software Iso-Designer - Jetter JetViewMobile 205 User Manual

Jetter AG
Fig. 7: Jetter software
ISO-Designer
Structure of EDC file
– example
User Manual – JetViewMobile 205

7 Firmware and system menu

This section describes how to load the firmware and system menu into the control
unit. The following options are available:
■ Via USB
■ Via CAN bus
Both require special Accessories

7.1 Creating an EDC file

The EDC file contains all the information needed to update the firmware, includ-
ing the system menu.
The EDC file must be generated. Follow these steps:
1.
Unpack the corresponding firmware package. This package is provided for
you by Jetter Support (support@jetter.de).
2.
Run script edc_make.bat .
ð
3 files are generated, one for each of the available interfaces:
41434445.EDC : Updating the firmware and system menu via USB
■
■ 41434445_EDC_x_x_x_x_.hex : Updating the firmware and system menu via
CAN bus
41434445_Emergency.hex : Update firmware and system menu via RS232
■
(not supported).

7.2 Description of the IOP file of the system menu

The system menu is written by an IOP file that is usually created using ISO-De-
signer software from Jetter.
Running script edc_make.bat , which is included in the firmware package, links
the IOP file with the files of the firmware in an EDC file and transfers them to-
gether to the control unit (Creating an EDC file).
4544-4334;1.6.0.48;41434445; output file (EUID is hardware-
dependent)
4669-726d;1.6.0.48;small_HMI.hex; firmware
426f-6f74;1.0.0.2;bootloader_v2.hex; Bootloader
496f-7072;1.0.0.0;MyProject1.iop; customer-specific system
menu
4c5f-3f3f;0.0.0.8;system_menu_de.iop; system menu (addi-
tional language)
5069-6374;1.0.0.3;start_up.png; illustration on start screen
Where:
■ Column 1 (496f-7072) is the EUID that identifies the content of the system
menu.
It must not be changed!
■ Column 2 is the version number of the IOP file of the system menu; available
at runtime.
■ Column 3 (MyProject1.iop) is the name of the IOP file.
Adapt the content of this column to the name of your IOP file if necessary.
■ Column 4 is the comment field. It is not compiled.
[} 39].
Firmware and system menu | 7
20