MOTO GUZZI V100 Mandello Instruction Manual page 21

Table of Contents

Advertisement

The dashboard has an immobilizer system which prevents start-up in case the system
does not identify a key which has been stored before.
The vehicle is delivered to the customer with two pre-programmed keys. The dash-
board accepts a maximum of four keys at the same time: contact an Official Moto
Guzzi dealer to enable these keys or to disable a key that has been lost. Upon vehicle
delivery, approximately ten seconds after the key is set to ON, the instrument cluster
requests a personal five-digit code to be entered.
See the chapter "Advanced functions" for instructions on modifying the personal
code
02_05
In case of code entry request, a box with variable values from 0 to 9 will be shown on
the display using the MODE navigation buttons. Confirm the selection with a short
press of the MODE SET button until completing the five digits; once all digits are
entered, complete the operation by turning the ignition key to the OFF position.
It is important to remember the personal code because:
the vehicle can be started if the immobilizer system is faulty
the dashboard need not be replaced should the ignition switch be
changed
new keys can be programmed
NOTE
IF THE PERSONA CODE IS NOT MEMORISED AND THE VEHICLE IS USED, THE
MESSAGE DISAPPEARS AFTER 10 SECONDS BUT REAPPEARS WITH EACH
KEY ON.
NOTE
THE FACTORY SET CODE IS COMPOSED OF FIVE ZEROES.
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

V100 mandello s

Table of Contents