MOTO GUZZI V100 Mandello Instruction Manual page 118

•
To adjust the spring pre-load, it is necessary to disconnect the connector (1)
from the stem plug, so as not to twist the wiring harness during the adjustment
operations.
03_13
TO AVOID DAMAGING THE CONNECTOR, PRESS THE TAB (2) ON THE INDI-
CATED POINT AND THEN CAREFULLY REMOVE THE CONNECTOR.
PAY SPECIFIC ATTENTION WHEN DISCONNECTING THE CONNECTORS, TO
AVOID DAMAGING THEM, WHICH WOULD COMPROMISE THE OPERATION OF
03_14
THE VEHICLE.
•
Using a spanner, turn the adjusting nut (3) clockwise to increase the pre-load
or anti-clockwise to decrease it.
•
Repeat the adjustment operations for the second stem, taking care to adjust
both stems equally.
SET THE SPRING PRE-LOADING AND THE EXTENSION HYDRAULIC BRAKING
OF THE FRONT FORK ACCORDING TO THE VEHICLE USE CONDITIONS.
03_15
118