Table of Contents
Advertisement
IMPORTANT! The tool must be at a standstill when you set the torque with the se ing ring.
Drilling (Fig.5)
For drilling purposes, move the set-collar to the last step "Drill". In this se ing the slip clutch is inactive.
The maximum torque is available in drilling mode.
Forward/Reverse switch (Fig.6)
With the slide switch above the On/O switch you can select the direction of rotation of the cordless
drill and secure it against being switched on accidentally. You can choose between clockwise and
anticlockwise rotation. To avoid causing damage to the gearing it is advisable to change the direction of
rotation only when the tool is at a standstill. The ON/OFF switch is blocked when the slide switch is in
centre position.
ON/OFF switch (Fig.6)
Infinitely variable speed control is possible with the ON/OFF switch. The further you press the switch,
the higher the speed of the ba ery cordless drill.
Changing over from 1st gear to 2nd gear (Fig.7)
You can work at a higher or lower speed depending on the position of the selector switch. To avoid
damaging the gear unit you should only change over gears when the tool has stopped.
Ba ery capacity indicator (Fig.8)
The 3 color LEDs will indicate the status of ba ery capacity as soon as you press the ON/OFF switch (4).
All LEDs illuminate: The ba ery is fully charged.
The yellow and red LED illuminate: The ba ery has an adequate remaining charge.
Red LED: The ba ery is empty, recharge the ba ery.
LED lamp (Fig.8)
The LED lamp (10) can be used in poor lighting conditions to illuminate the area where you want to drill
or screw. The LED lamp (10) will be lit automatically as soon as you press the ON/OFF switch (4).
Changing the tool (Fig.9)
IMPORTANT! Set the changeover switch (3) to its centre position whenever you carry out any work (for
example changing the tool, maintenance work, etc.) on the cordless drill.
• The cordless drill is fi ed with a quick action chuck (9) with an automatic spindle stop.
• Open the chuck (9). The chuck opening (a) must be large enough to hold the tool (drill bit or screwdri-
ver bit).
• Select the suitable tool. Push the tool as far as possible into the chuck opening (a).
• Tighten the chuck (9) and then check that the tool is secure.
Wear ear-mu s
The impact of noise can cause damage to hearing. Total vibration values (vector sum of three
directions) determined in accordance with EN 60745.
LpA: sound pressure level 71.5 dB (A)
KpA: uncertainly 3 dB (A)
LWA: sound power level 82.5 dB (A)
KWA: uncertainly 3 dB (A)
9
Advertisement
Table of Contents
