Before Starting; Operation - Energizer eZLD158 User Manual

4. DESCRIPTION PART FIG.1
1. Torque selector
2. Ba ery capacity indicator
3. Changeover switch
4. ON/OFF switch
5. Li-Ion-Ba ery pack
6. Ba ery charger
7. Selector switch for 1st/2nd gear
8. Pushlock bu on
9. Quick-change drill chuck
10. LED lamp

5. BEFORE STARTING

Be sure to read the following information before you use your cordless drill for the first time:
a) Charge the ba ery pack with the charger supplied.
b) Only ever use sharp drill bits and screwdriver bits which are suitable for the purpose and in faultless
condition.
c) Always check for concealed electric cables and gas and water pipes when drilling and screwing in
walls.

6. OPERATION

Charging the ba ery pack (Fig.2-Fig.3)
a) Remove the ba ery pack (5) from the handle, pressing the pushlock bu ons (8) downwards to do so.
b) Check that your mains voltage is the same as that marked on the rating plate of the ba ery charger.
Plug the mains plug of the charger (6) into the mains socket outlet.
c) Push the ba ery pack onto the ba ery charger. The red LED will come on to indicate that the ba ery
pack is being charged. When the charging process is finished, the red LED will extinguish and green LED
will be permanently lit.
d) The temperature of the ba ery pack may rise slightly during the charging operation. This is normal.
If the ba ery pack fails to become charged, please check
• Whether there is voltage at the socket-outlet;
• Whether there is proper contact at the charging contacts on the charger.
If the ba ery still fails to become charged, please return to our Customer Service Department.
• The charger;
• The ba ery pack.
To ensure that the ba ery pack provides long service you should take care to recharge it promptly.
You must recharge the ba ery pack when you notice that the power of the cordless drill drops.
Never fully discharge the ba ery pack. This will cause the ba ery pack to develop a defect.
ATTENTION: Please charge the ba ery pack regularly, for example, once every 6 months.
Torque se ing (Fig.4)
The cordless drill is fi ed with a mechanical torque selector. The torque for a specific size of screw is
selected with the torque selector (1). The correct torque depends on several factors:
· On the type and hardness of material in question;
· On the type and length screws used;
· On the requirements needing to be met by the screwed joint.
The clutch disengages with a grating sound to indicate when the set torque is reached.
8