Installation Instructions - Haverland IGLU 2023 Installation Manual

2. INSTALLATION
UK

2. INSTALLATION INSTRUCTIONS

● The unit should be placed on a firm foundation to minimize noise and vibration. For safe and
secure positioning place the unit on a smooth, level floor strong enough to support the unit.
● The unit has casters to aid placement, but it should only be rolled on smooth, flat surfaces. Use
caution when rolling on carpeted surfaces. Use caution and protect floors when rolling over wood
floors. Do not attempt to roll the unit over objects.
● The unit must be placed within reach of a properly rated grounded socket.
● Never place any obstacles around the air inlet or outlet of the unit.
● Allow at least 18"(45cm) of around and above space away from the wall for efficient working.
● The hose can be extended, but it is the best to keep the length to minimum required. Also make
sure that the hose does not have any sharp bends or sags.
When use the appliance in cool mode, the hot air exchange of the condenser must be exhausted out
of the room completely.
First position unit on a flat floor and make sure there's a minimum of 18"(45cm) clearance around the
unit, and is within the vicinity of a single circuit outlet power source.
1. Extend either side of the hose (Fig. 1), and screw the hose inlet (Fig. 2).
2. Extend the other side of the hose and screw it to the hose outlet (Fig. 3).
3. Install the hose inlet into the unit (Fig. 4).
4. Affix the hose outlet into the window slider kit and seal. (Fig. 5 & 6).
IGLU-23
26