Before Use; Installing The Appliance; First Use - DeLonghi CAM51025MB User Manual

BEFORE USE

Checking the appliance
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present. Do
not use the appliance if it is visibly damaged. Contact De'Longhi
Customer Services.

Installing the appliance

When you install the appliance, you should respect the follow-
ing safety warnings:
• The machine gives off heat. After positioning the machine-
on the worktop, leave a space of at least 1.18 in / 3 cm be-
tween the surfaces of the machine and the side and rear
walls and at least 5.6 in / 15 cm above the coffee maker.
• Water penetrating the machine could cause damage. Do
not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• Arrange the cord in such a way that it cannot be damaged
by sharp edges or come with contact with hot surfaces
(e.g. electric hot plates).
• Adjust the cord length and store the excess in the cord
guide under the machine.
Connecting the appliance
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified pro-
fessional.
The first time you use the appliance, rinse with hot water all
removable accessories which may come into contact with water.
The first time you use the machine, the water circuit is empty
and the appliance could be very noisy.The noise becomes less
as the circuit fills.
Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee in
the grinder. The machine is, however, guaranteed to be new.

FIRST USE

• Connect the appliance to a mains socket.
The button blink and the
• Remove the water tank (F), fill to the MAX level (marked
on the tank) with fresh water, then put the tank back in the
espresso style
icon lights on.
5
appliance correctly.
• Place a container holding a minimum of approx 7 floz/200
ml underneath coffee spout (H).
• Press button. The appliance delivers water from the
coffee spout.
3 oz 8 oz 12 oz
light gold bold
strength
The coffee machine is now ready for normal use.
The first time you use the appliance, you need to make
some coffees before it starts to give satisfactory results.
SETTINGS
Pressing button it is possible to set: AM-PM or 24h, hours
and minutes, acoustic signal, temperature, water hardness and
auto-on.
Set the time:
• Press button; AM is displayed. Press
set AM, PM or 24h.
• To set the time press
button to set the desired hour. Press
again; the minutes blink; press
sired minutes is displayed.
Auto-on:
The appliance will deliver the selected drink at the set time;
place a cup or a mug under the coffee spout. Auto-on has to
16 oz 20 oz 24 oz
coffee
over ice
special
button to
button; the hour blink; press
button until the de-
size
type
brew
button