DeLonghi CAM51025MB User Manual page 10

Press the two red release buttons inwards and at the same
time pull the infuser outwards. Soak the infuser in water for
about 5 minutes, then rinse under the tap.
Do not use detergents to clean the infuser as this could
cause damage.
Remove any coffee residues left in the infuser housing.
After cleaning, replace the infuser by sliding it onto the in-
ternal support, then push the PUSH symbol fully in until it
clicks into place.
Please note: The infuser cannot be extracted when the
machine is on. Make sure the machine has run the shut-
down procedure correctly.
Pre-ground coffee funnel (B): Check regularly (about
•
once a month) that the pre-ground coffee funnel is not
blocked. If necessary, remove coffee deposits with a brush.
• Water tank (F): clean the water tank regularly (about
once a month) with a damp cloth and a little mild washing
up liquid.
Coffee spout (H): clean the coffee spoutregularly with a
•
sponge or cloth. Check the holes in the coffee spout are not
blocked. If necessary, remove coffee deposits with a tooth-
pick.
DESCALING
Descale the machine when the
Please note: Before use, read the instructions and the labelling
on the descaler pack. It is important to use De'Longhi descaler
button lights on.
only. Using unsuitable descaler and/or performing descaling in-
correctly may result in faults not covered by the manufacturer's
guarantee. Descaler could damage delicate surfaces. If the prod-
uct is accidentally spilt, dry immediately. The whole process will
take about 30 minutes.
• Press button for 3 seconds.
• The icon lights on.
• Empty drip tray (R) and coffee grounds container (Q).
• The icon lights on.
• Pour the descaler into the water tank (corresponding to a
3.5 floz/100ml pack) then add water (about 35 floz/1 litre)
and put the water tank back.
• Place a container holding a minimum of 70 floz/2 litres un-
derneath coffee spout (H).
• Press button.
• The button blink. The
• The descale programme starts and the descaler liquid
comes out of the coffee spout. A series of rinses and pauses
is performed automatically to remove all the scale residues
inside the coffee machine.
• The appliance is now ready for rinsing through with clean
water. The icon lights on. Empty the container used to
collect the descaler solution. Extract the water tank, empty,
rinse under running water.
• Empty drip tray (R) and coffee grounds container (Q). The
icon lights on. Fill with fresh water up to the MAX level
and put back in the appliance.
• Place the container used to collect the descaler solution
empty under the coffee spout.
• Press button. Hot water is delivered from the coffee
spout. The icons lights on.
• At the end of the cycle the
• At the end of the rinse, extract the tray assemble (L,) re-
move, empty and replace the disposal water container (P).
Empty the container used to collect the rinse water, remove
the water tank and fill with fresh water up to the MAX level,
then put back in the appliance.
The descaling cycle is now complete and the appliance turn
off.
• When the appliance turn on again, the
Press button. The coffee machine is now ready for
use.
Please note: It is possible to make an extra descaling cycle by
pressing the button for 3 seconds.
9
and icons lights on.
icons lights on.
button blink.