Table of Contents
Advertisement
en Installation and connection
Use dark-coloured, black-coated or enamelled baking
tins.
¡ These types of baking tin absorb the heat particu-
larly well.
Open the appliance door as little as possible during
operation.
¡ This maintains the temperature in the cooking com-
partment and eliminates the need for the appliance
to reheat.
When baking multiple dishes, do so in succession or
in parallel.
¡ The cooking compartment is heated after baking
the first dish. This reduces the baking time for the
second cake.
If the cooking time is relatively long, you can switch
the appliance off 10 minutes before the cooking time
ends.
¡ There will be enough residual heat to finish cooking
the dish.
Remove any accessories that are not being used from
the cooking compartment.
¡ Accessories that are not being used do not need to
be heated.
Allow frozen food to defrost before cooking.
¡ This saves the energy that would otherwise be re-
quired to defrost it.
Note:
The appliance requires:
¡ A maximum of 1 W in standby mode with the dis-
play switched on
¡ A maximum of 0.5 W in standby mode with the dis-
play switched off
4 Installation and connection
You can find out where and how best to install your ap-
pliance here. You will also learn how to connect your
appliance to the power supply.
4.1 Fitting the adjustable feet
Your appliance is supplied with a set of adjustable feet.
¡ Remove all parts that are not permanently fixed, es-
pecially the pan supports and burners.
¡ Remove any accessories from the oven.
¡ Lift one side of the appliance off the floor and tilt it
slightly.
8
Saving energy
If you follow these instructions, your appliance will use
less energy.
Choose a burner roughly the same size as your pan.
Centre the cookware on the hob.
Tip: Cookware manufacturers often give the upper
diameter of the saucepan. It is often larger than the
base diameter.
¡ Unsuitable cookware or incompletely covered cook-
ing zones consume a lot of energy.
Cover saucepans with suitable lids.
¡ Cooking without a lid consumes considerably more
energy.
Lift lids as infrequently as possible.
¡ When you lift the lid, a lot of energy escapes.
Use a glass lid.
¡ You can see into the pan through a glass lid
without having to lift it.
Use pots and pans with flat bases.
¡ Uneven bases increase energy consumption.
Use cookware that is suitable for the quantity of food.
¡ Large items of cookware containing little food need
more energy to heat up.
Cook with only a little water.
¡ The more water that is contained in the cookware,
the more energy is required to heat it up.
Turn down to a lower power level early on.
¡ If you use an ongoing power level that is too high,
you will waste energy.
¡ Screw the adjustable feet into the mounting holes
on the underside of the appliance.
Note: If you then move the appliance, screw the ad-
justable feet in fully.
¡ Only finally align the appliance once the electricity
and gas have been connected and all of the installa-
tion work is complete.
Advertisement
Table of Contents
