Porter-Cable PTX4 Instruction Manual page 3

RISK OF LOSS OF HEARING
WHAT COULD HAPPEN
• Long term exposure to noise produced from the opera-
tion of air tools can lead to permanent hearing loss.
RISK TO BREATHING INHALATION HAZARD
WHAT COULD HAPPEN
• Abrasive tools, such as grinders, sanders, and cut-off
tools generate dust and abrasive materials which can
be harmful to human lungs and respiratory system.
• Some materials such as adhesives and tar, contain
chemicals whose vapors could cause serious injury
with prolonged exposure.
RISK OF INJURY
WHAT COULD HAPPEN
• Tools left unattended, or with the air hose attached can
be activated by unauthorized persons leading to their
injury or injury to others.
• Air tools can propel fasteners or other materials
throughout the work area.
• A wrench or a key that is left attached to a rotating part
of the tool increases the risk of personal injury.
• Using inflator nozzles for duster applications can cause
serious injury.
• Air tools can become activated by accident during
maintenance or tool changes.
• Air tools can cause the workpiece to move upon con-
tact leading to injury.
• Loss of control of the tool can lead to injury to self or
others.
• Poor quality, improper, or damaged tools such as
grinding wheels, chisels, sockets, drills, nailers,
staplers, etc., can fly apart during operation, propelling
particles throughout the work area causing serious
injury.
• Fasteners could ricochet or be propelled causing
serious injury or property damage.
HAZARD
HAZARD
HAZARD
HOW TO PREVENT IT
• Always wear ANSI S3.19 hearing protection.
HOW TO PREVENT IT
• Always wear MSHA/NIOSH approved, properly fitting
face mask or respirator when using such tools.
• Always work in a clean, dry, well ventilated area.
HOW TO PREVENT IT
• Remove air hose when tool is not in use and store tool
in secure location away from reach of children and or
untrained users.
• Use only parts, fasteners, and accessories
recommended by the manufacturer.
• Keep work area clean and free of clutter. Keep children
and others away from work area during operation of
the tool.
• Keep work area well lit.
• Remove adjusting keys and wrenches before turning
the tool on.
• DO NOT use inflator nozzles for duster applications.
• Remove air hose to lubricate or add grinding
attachments, sanding discs, drills, etc. to the tool.
• Never carry the tool by the hose.
• Avoid unintentional starting. Don't carry hooked-up tool
with finger on trigger.
• Repair servicing should be done only by an authorized
service representative.
• Use clamps or other devices to prevent movement.
• Never operate tool while under the influence of drugs
or alcohol.
• Don't overreach. Keep proper footing and balance at all
times.
• Keep handles dry, clean, and free from oil and grease.
• Stay alert. Watch what you are doing. Use common
sense. Do not operate tool when you are tired.
• Always use tool attachments rated for the speed of the
power tool.
• Never use tools which have been dropped, impacted or
damaged by use.
• Use only impact grade sockets on an impact wrench.
• Do not apply excessive force to the tool, let the tool
perform the work.
• Never point discharge of tool at self or others.
• Do not pull trigger unless tool contact safety device is
against work surface.
• Never attempt to drive fasteners into hard surfaces
such as steel, concrete, or tile.
• Take care to avoid driving a fastener on top of another
fastener.
• Position tool carefully so that fasteners will be delivered
to the proper location.
3- ENG
D22715