Agila Easylift: Setting The End Positions Of The Spring Arm - Dräger Agila Instructions For Use Manual

Agila Easylift: Setting the end positions of the spring arm

WARNING
Danger of personal injury and/or equipment
damage
The spring arm is braked with a pre-setting
and set to the planned nominal load. If the load
is removed and the brake is released after this,
this leads to an accelerated upward
movement of the spring arm.
Before removing the load and releasing the
brake, lock the system, see "Locking the
system" on page 31.
The height of the spring arm can be freely adjusted.
A
1 Move the spring arm to the desired position and
2 Lock the system to prevent upward movement
by pressing the red key (A) on the handle (at
least 3 seconds).
3 Take the load from the media head/media
column.
Instructions for use Agila
Setting the top end position of the spring
arm
B
A
1 Take off cover (A).
2 Set the top end position with the M12 adjusting
screw (B).
 Clockwise: top end position lower
 Counterclockwise: top end position higher
3 Reattach cover (A).
Troubleshooting
37