Table of Contents
Advertisement
FORK ASSEMBLY
MOUNTING CASTER TO CLD FORK
ASSEMBLY (FIGURE 2)
WARNING
If not changing the wheelchair's current configu-
ration (seat angle, caster size or seat-to-floor
height), refer to the chart below to determine
the caster and/or rear wheel mounting positions.
If changing the wheelchair's current configuration
(seat angle, caster size or seat-to-floor height), re-
fer to the 9000 Wheelchair Service Manual, Part
Number 1076155.
When installing the CLD onto 9000 wheelchairs with
specific measurements, the wheelchairs MUST be
equipped with the space saver arms. Refer to the
chart below for specific measurements.
Caster Size
Seat-to-floor
6
15.5
6
16.5
6
17.5
6
17.5
8
17.5
8
17.5
8
18.5
8
19.5
*Space Saver Arms required for 9000 wheelchairs.
NOTE: Measurements in the chart are in inches.
INSTALLING CLD FORK ASSEMBLY
ONTO WHEELCHAIR (FIGURE 3)
1. Remove the hex nut from the CLD fork stem.
2. Insert the CLD fork stem into the caster headtube.
3. Secure the CLD fork assembly to the caster headtube
with the hex nut.
NOTE: DO NOT overtighten the hex nut. The CLD fork
should turn freely with no side to side play.
4. Install the caster journal cap onto the caster headtube.
1. Refer to the chart below to determine which mount-
ing position should be used.
2. Secure the caster to the CLD fork assembly in the
mounting position determined in STEP 1 with the hex
head bolt, washers and the hex nut as shown in FIG-
URE 2. Tighten securely.
FIGURE 2 - MOUNTING CASTER TO CLD FORK
9000 WHEELCHAIRS
Caster Mounting Position
Top
Middle
Bottom
Bottom
Top
Top
Middle
Bottom
CLD Fork Stem
FIGURE 3 - INSTALLING CLD FORK ASSEMBLY
7
CLD Fork
Assembly
Hex Nut
Washers
ASSEMBLY
Rear Wheel Size
Rear Wheel Position
20
22
24
20
20
24
22
24
ONTO WHEELCHAIR
PROCEDURE 2
F
O
R
K
A
Hex
S
Screw
S
E
M
B
L
Y
*Top
*Top
*Top
Bottom
Bottom
*Top
Bottom
Bottom
Caster
Journal
Cap
Hex Nut
Caster
Headtube
Fork
Advertisement
Table of Contents
