Controller Operation - Zaber T-CON3 User Manual

3.

Controller Operation

The main control screen of the T-CON3 enables the user to quickly and accurately select and
move an actuator to the desired position. Select any actuator by pressing the button next to the
clear arrow on the appropriate line. A selected line is indicated by a black arrow.
Change the step size by pressing the button next to the clear arrow on the bottom line, and
turning the rotary knob. The available standard step sizes are: 50000, 20000, 10000, 5000, 2000,
1000, 500, 200, 100, 50, 20, 10, 5, 2, 1, and user-defined step size (see section on Main Menu,
User Step command for more information on user-defined step size).
When the step size is set to the desired value, select one of the actuators again and turn the knob
to move the actuator in increments of the step size indicated on the bottom line.
1 4550 bit
2 1200 bit
Step
The T-CON3 also has many additional features that may be accessed by going into either the
Main Menu, or the Actuator Menu. Access the Main Menu by selecting the bottom line, and
pressing the rotary knob instead of turning it. Access the Actuator Menu by selecting one of the 3
top lines and pressing the rotary knob. From either Menu you may press the rotary knob again to
return to the main control screen.
Copyright © Zaber Technologies Inc.
200 bit
Page 8 of 22