Table of Contents
Advertisement
2.
Quick Start Guide
This section describes how to get the controller up and running. The quick start guide assumes
that the user has the following components ready:
• T-CON3 controller
• One or more T-series motorized products (T-LA series, T-HLA series, T-LS series, T-
LLS series, T-MM2 series, etc)
• 12V Power supply with 2.1mm center-positive plug
2.1 Power Up
The first step is to verify that the controller powers up by itself. Do not connect any actuator to
the controller yet. Plug the 12V power adaptor into a live power bar or live wall socket. Plug
the power plug into the T-CON3 controller to power up the device. There is no separate power
switch. The LCD backlight should be lit and the splash screen will be displayed.
ZABER
www.zaber.com
T-CON3
Initializing...
The controller will immediately begin searching for any connected actuators. Since no actuator
is connected, after trying to initialize for about 2 seconds on the splash screen, the controller will
display on the lowest line "Device not found". Then it will attempt to search for devices again,
finally giving up and displaying the following screen:
Initializing...
Device not found
Check connection
The above screen verifies that the device powers up and is working properly. Pressing the button
next to "Retry" will instruct the controller to search for external actuators again, and return to the
same screen if no actuators are found.
Copyright © Zaber Technologies Inc.
v1.00
Retry
Page 4 of 22
Advertisement
Table of Contents
