Setting By Means Of R100 - Grundfos CRE Instructions Manual

6.4.2 Pump in control mode uncontrolled
Example
In control mode uncontrolled, the pump performance is set within
the range from min. to max. curve. See the figure below.
H
Pump performance setting, control mode uncontrolled

6.5 Setting by means of R100

The pump is designed for wireless communication with Grundfos
remote control R100.
R100 communicating with the pump via infra-red light
During communication, the R100 must be pointed at the control
panel. When the R100 communicates with the pump, the red
indicator light will flash rapidly. Keep pointing the R100 at the
control panel until the red LED diode stops flashing.
The R100 offers setting and status displays for the pump.
The displays are divided into four parallel menus (see fig. 'Menu
overview'):
0. GENERAL (see operating instructions for the R100)
1. OPERATION
2. STATUS
3. INSTALLATION
The figure above each individual display in fig. 'Menu overview'
refers to the section in which the display is described.
Q
29