Toyota HILUX 2008 Owner's Manual page 134

AM
Push "AM" to turn on the radio and select
the AM band. "AM" will appear on the
display.
If the audio system is off, you can turn
on the radio by pushing "AM". Also, push
"AM" to switch from cassette or compact
disc operation to radio operation.
AUDIO CONTROL
Manual tone adjustment function—
This knob is used to adjust the tone
manually.
For low−pitch tone adjustment,
"AUDIO CONTROL" repeatedly until "BAS"
appears on the display. Then turn the
knob to suit your preference.
The display will show the range from
"BAS −5" to "BAS 5".
For high−pitch tone adjustment,
"AUDIO CONTROL" repeatedly until "TRE"
appears on the display. Then turn the
knob to suit your preference.
The display will show the range from
"TRE −5" to "TRE 5".
Sound balance adjustment function—
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
For front/rear adjustment, push "AUDIO
CONTROL" repeatedly until "FAD" appears
on the display. Then turn the knob to
adjust the front/rear balance.
The display will show the range from
"FAD−F7" to "FAD−R7".
For left/right adjustment, push "AUDIO
CONTROL" repeatedly until "BAL" appears
on the display. Then turn the knob to
push
adjust the left/right balance.
The display will show the range from
"BAL−L7" to "BAL−R7".
Sound field adjustment—
To adjust the sound field, push "AUDIO
CONTROL" until "EQ" appears on the dis-
push
play. Then turn the knob to select "COM-
PACT", "SEDAN" or "MINIVAN".
DISC
Push "DISC" to switch from radio or cas-
sette operation to compact disc operation.
If the audio system is off, you can turn
on the compact disc player by pushing
"DISC". In both cases, a disc must alrea-
dy be loaded in the player.
When the audio system is set into com-
pact disc operation, the display shows the
track or, track and disc number currently
being played.
If the player malfunctions, your audio sys-
tem will display the following error mes-
sages.
If "WAIT" appears on the display, it indi-
cates that the inside of the player unit
may be too hot due to the very high ambi-
ent temperature. Remove the disc from
the player and allow the player to cool
down.
If "Err 1" appears on the display, it
indicates the disc is dirty, damaged, or it
was inserted up−side down. Clean the
disc or insert it correctly.
If "Err 3" or "Err 4" appears on the
display, it indicates there is a trouble in-
side the system. Eject the disc or maga-
zine. Set the disc or magazine again.
If "NO DATA DISC" appears on the dis-
play, it indicates that a disc with no mp3
data has been inserted. Remove the disc
from the player and insert a mp3 data
disc.
123