Table of Contents
Advertisement
KEANE MONROE
a member of the record group
MONROE, NC, USA 28111
Parallel Arm Installation with Panic Breakaway
Table for Hole Location
Depth of
Dim. "A"
Reveal
0 to 2-1/2"
2-9/16" to 4"
4-1/16" to 5"
5-1/16" to 6"
Note: Any reveal greater than 6" requires a special
bracket and special instructions. Contact the KM
Technical department.
Centerline of
Center Pivot
Hole Instructions
For Metal Doors with 1/8" surface thickness, drill #7 hole and tap for 1/4-
20x5/8" machine screw (4 holes). For Metal Doors with less than 1/8" surface
thickness or Wood Doors, drill 3/16" pilot hole for #14x1 1/4" sheet metal screw
(4 holes).
Note: All hole locations shown above are located from centerline of pivot .
800 438 1937
Caution: Before proceeding with preparation of door,
!
determine the depth of reveal. See Table below.
Door must be center pivoted or be capable of swinging
!
in both directions.
Door Bracket
Length Used
9-3/4"
7"
7-1/8"
7"
11"
6-3/8"
Dim. "A"
7-3/4"
Inside Face of Door
SERIES 2000
INSTALATION INSTRUCTIONS
PARALLEL ARM INSTALLATION W/ PANIC BREAKAWAY
Panic Breakaway
See Hole Instructions
6"
PAGE 13.
Operator
D
o
Door-
o
Bracket
r
length
Reveal
3/8"
1-7/16"
Advertisement
Table of Contents
