Table of Contents
Advertisement
fig. 15
❒ make sure the compressor switch E-
fig. 16 is set to 0 (off), start the en-
gine and fit plug D-fig. 15 into the cig-
ar lighter outlet and then turn on the
compressor by setting switch E-fig. 16
to I (on). Inflate the tyre to the pres-
sure specified in paragraph "Cold tyre
inflation pressure" in section "Techni-
cal Specifications". Check tyre pressure
on gauge F-fig. 16 with compressor off
to obtain precise reading;
F0C0515m
fig. 16
❒ If after 5 minutes it is still impossible
to reach at least 1.5 bar, disengage com-
pressor from valve and current outlet,
then move the car forth for approx. ten
metres in order to distribute the seal-
ing fluid inside the tyre evenly, then re-
peat the inflation operation;
❒ If after this operation it is still impossi-
ble after 5 minutes to reach at least 1.8
bar, do not start driving since the tyre
is excessively damaged and the quick
tyre repair kit cannot guarantee suit-
able sealing, contact Fiat Dealership;
❒ If reaching the tyre pressure specified
in paragraph "Cold tyre inflation pres-
sure" in section "Technical Specifica-
tions", start driving immediately;
WARNING
Apply the sticker in a visible
position for the driver to in-
F0C0516m
dicate that the tyre has been treat-
ed with the quick tyre repair kit. Dri-
ve carefully especially when corner-
ing. Do not exceed 80 km/h. Avoid
heavy braking and accelerating.
❒ after driving for about 10 minutes stop
and check again the tyre pressure; pull
up the handbrake;
WARNING
If the pressure falls below 1.8
bars, do not drive any fur-
ther: the quick tyre repair kit Fix & Go
automatic cannot guarantee proper
hold because the tyre is too much
damaged. Contact Fiat Dealership.
179
Advertisement
Chapters
Table of Contents
