Overlays - Where To Get Them And How To Make Them Yourself If Required - HP RPN SCIENTIFIC WP 34S Owner's Manual

Overlays – Where to Get Them and How to Make Them Yourself if Required
(the picture shall be 68
adhesive tape, and you are done – the flexibility of this setup allows actuating the keys
though there are no holes in your overlay. It will serve you well until the vinyls will arrive.
WP 34S Owner's Manual
After flashing successfully, a keyboard overlay is
very helpful for further work since most labels
deviate from those on said business calculators.
You get fine adhesive vinyl overlays from Eric
Rechlin at http://commerce.hpcalc.org/overlay.php.
You can choose if you want them with white labels on
the prefix keys (the original design, shown left) or with f,
g, and h in their respective colours (shown above).
Supporters of the 'Great American Divide' can apply
them with a
Eric's vinyls come pre-stamped. Detach the key plate
part of it from the carrier paper first. Adjust it carefully
over your WP 34S and attach it starting with the section
between ENTER and STO, then proceeding towards the
top and bottom. The vinyl shall not contact the keys.
After covering the key plate, detach the individual key
labels and apply them to the respective keys. If you
need to lift a label once attached – e.g. for readjusting it
– a sharp knife will serve you best: put it between key
and label and lift a corner of the label, then take it with
your finger nails or tweezers and peel it off.
If Eric's vinyls are not available for any reason, you
can make preliminary paper overlays most easily
using the picture shown left. Print this page to scale
mm
wide), cut it out, span it over your WP 34S using transparent

instead of a
Edition 3.1

as well.
Page 151 of 211