Table of Contents
Advertisement
With ENG 3 and after
When the last operation executed has returned a complex result, C is lit in the top left
When any complex operation is executed, the result of this function is in X and Y, and
of the LCD pointing to the fact that you will find the result of this function in X and Y.
the imaginary part y (indicated by
Floating point decimal numbers within
directly in default DECM. Within this range, your WP 34S calculates with 16 digits.
Values less than 10
, error 4 or 5 will appear unless flag D is set (see
2.
and
display the full number
mantissa of standard floating point numbers (imagine a radix mark after the first digit),
and all digits of the exponent almost like in scientific display format. All this is shown in
one temporary message, working like the SHOW command in the HP-42S.
For example,
3. Fraction mode works similarly to the one in the HP-35S or the HP-32SII. In particular,
DENMAX sets the maximum allowable denominator (see the IOP). Display will look like
in the examples below – fractions are adjusted to the left. If the fraction is exactly
equal, slightly less, or greater than the floating point number converted, =, Lt, or Gt is
indicated in the exponent, respectively. On your WP 34S, fraction mode can handle
numbers with absolute values less than 100,000 and greater than 0.0001. Maximum
denominator is 9999. Underflows and overflows will be displayed in the format set
before fraction mode was entered.
Example: Enter the following:
0
3
WP 34S Owner's Manual
, you will get
) is displayed in the top row dot matrix LCD.
i
– 398
are set to zero (see
3
returns
or
Appendix B
x
, i.e. all sixteen digits present internally in the
reading 3.100 627 668 ...∙ 10
and you will see:
↕ DENANY
↕ DENMAX
Edition 3.1
may easily be entered
for the reasons). For results
Appendix
C).
in catalog MODE.
initializes.
sets maximum precision.
since 1/3 > 0.333333333333.
since this is exact.
Page 41 of 211
1
.
Advertisement
Table of Contents
