Table of Contents
Advertisement
Power can be controlled manually from the board using the
side of the board (see Section 3.1 Evaluation Board Overview).
Depending on the setting of
power.
3.3 Control Buttons and Switches
The control buttons (see Fig. 3.1 The base board for to PX30-uQ7 module) provide the following functionality:
•
toggles the module power supply.
•
triggers a module reset.
•
,
and
Several slider switches are located on the lower left:
•
is routed to a GPIO on the module, simulates lid open/close.
•
(
•
(
3.4 CPU Fan
Operation in high environmental temperatures may require a CPU fan. The fan connector is located next to the bottom right
corner of the Q7 expansion area.
v1.0.1-8-g2dd91c8
Page 6
Fig. 3.2: 12V Power connector
(
are routed to GPIOs on the uQ7 module.
), as described above, sets the state after power loss.
) forces SD card boot or the normal boot order, respectively.
control buttons and switches, located on the lower right
) switch, the board will boot as soon as it receives
Advertisement
Table of Contents
