Then, insert a micro-USB cable into the USB-OTG port (see Fig. 3.8 USB 2.0 OTG port (dual-role port: can be used as a host or
device interface)) on the baseboard and into a USB port of your host PC.
Then, power cycle the device by unplugging and replugging the power supply or by pressing the
command on your host PC should return the following:
Now, put the
slider back into the
7.2.3 Flash the eMMC
Warning: The
slider must be back in
You will see rkdeveloptool making improbably quick write progress in this case.
To write the image file path stored in the variable
This step should take about 1 minute for the Debian image.
PX30-uQ7 User Manual
© Theobroma Systems Design und Consulting GmbH
mode.
mode, otherwise the eMMC is inaccessible and stays empty.
to the on-board eMMC, run:
button. The
v1.0.1-8-g2dd91c8
Page 27