Picture Id Settings - LG 75XE3C Owner's Manual

PICTURE ID Settings

• Only applies to certain models.
[PICTURE ID] is used to change the settings of a
specific set (display) using a single IR receiver for multi-
vision. Communication is possible between a monitor
with an IR receiver and other monitors using RS-232C
cables. Each monitor is identified by a Set ID. If you
AUDIO
assign the [PICTURE ID] using the remote control, only
(RGB/DVI)
RS-232C OUT
displays with matching PICTURE ID and Set ID can be
RS-232C IN
controlled remotely.
REMOTE
CONTROL IN
1
Assign the Set ID to the installed monitors as
shown below.
IR & Light Sensor
RS-232C cables
2
Press the red ON button on the remote control to
assign the PICTURE ID.
3
Assign the Set ID to the selection of your choice.
• A set with a different Set ID from the PICTURE ID
cannot be controlled by IR signals.
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
PICTURE ID
NOTE
• If PICTURE ID is set to 2, only the upper right monitor,
which has a Set ID of 2, can be controlled by IR
signals.
• If you press the green OFF button for PICTURE ID, the
PICTURE ID for all monitors are turned off. If you then
press any button on the remote control, all monitors
can be controlled by IR signals regardless of Set ID.
35