Sync Mode - LG 75XE3C Owner's Manual

12

Sync Mode

• Syncs the products to the time, brightness and content of one product.
• Off: Sync is disabled.
• RS-232C: Syncs multiple monitors connected via RS-232C.
- Master/Slave: These monitors can be set to Master or Slave. Only one monitor should be set to Master mode for
this feature to work properly.
- Time Sync: When Time Sync is set to On, the current time of the Master monitor is sent to multiple Slave monitors
connected via RS-232C to sync the time. The monitors are synced every hour after the initial sync when Time Sync
was set to On. (If any change occurs, there is an initial sync, and then the sync continues every hour.)
- Contents Sync: When Contents Sync is set to On, the Contents of the Master monitor are sent to multiple Slave
monitors connected via RS-232C to sync the Contents. This feature is only available for the monitors with Contents
Sync set to On and operates normally with a single video or image in the Contents.
- Backlight Sync: This feature changes the brightness of the monitor to match that of the Master monitor. Both the
Master monitor and Slave monitor must be configured as follows: Energy Saving: Auto and Backlight Sync: On. The
brightness sync interval is 1 minute, but when only slight changes in ambient brightness occur, the interval changes
to 10 minutes.
• Network: Syncs monitors connected to the same network. The monitor that authorized the SYNC NOW button
becomes the Master.
- How many connected screens: Enter the number of Slaves. A number from 1 to 225 can be entered and the default
value is 1.
- Select storage device: You can select Internal Memory or USB device.
- Select the file name: Up to 10 files can be selected from the List of files in the selected device. Selecting the files
will activate the SYNC NOW button at the top and make the next step available.
- Only MP4 files are supported, and all files must be located in the SyncPlay folder in the root directory of the device.
- Before using Network Sync, set the proxy server settings to Off.
• UPnP: Opens or blocks UDP port 1900, which is used for UPnP.
- The default is On. Setting this to Off blocks UDP port 1900, making the UPnP function unavailable.
- If this is set to Off, the 'Network' item of Sync Mode becomes inactive.
- If this is set to Off and Sync Mode was set to 'Network' , Sync Mode is switched to 'Off' and the 'Network' item
becomes inactive.
- If the UPnP value is changed, the function is not applied without a reboot.