Safety Notice; Data Plates And Certifications; Engine; Transmission - PREVOST H3-41 Maintenance Manual

SECTION 00 : GENERAL INFORMATION

4. SAFETY NOTICE

This maintenance manual has been prepared in
order to assist skilled mechanics in the efficient
repair and maintenance of PREVOST vehicles.
This manual covers only the procedures as of
manufacturing date.
Safety features may be impaired if other than
genuine PREVOST parts are installed.
Torque wrench tightening specifications must be
strictly observed. Locking devices must be
installed or replaced by new ones, where
specified. If the efficiency of a locking device is
impaired, it must be replaced.
This manual emphasizes particular information
outlined by the wording and symbols:
DANGER
Directs the operator's attention to unsafe
practices which could result in serious
personal injury or death.
WARNING
Directs the operator's attention to unsafe
practices which could result in serious
personal injury or severe damage to the
vehicle.
CAUTION
Directs the operator's attention to unsafe
practices where personal injury is not likely
but damage to vehicle components could
occur.
NOTE
Indicates supplementary information essential
to the proper operation of the vehicle.
Although, the mere
information does not eliminate the hazard,
understanding of the information will promote
its correct use.

4.1 DATA PLATES AND CERTIFICATIONS

Delay and confusion can be avoided by placing
the complete vehicle identification number of the
vehicle and the serial numbers of the engine on
parts orders and correspondence. Also, the
6
PA1615 Maintenance Manual All Series
reading of such
|
Section 00 revised September 2016

transmission,

axles,
chassis and other major components are
identified by serial numbers.

4.1.1 Engine

FIGURE 1: VOLVO D13 ENGINE DATA PLATE
Volvo D13 engine serial and model numbers are
stamped on the cylinder head. Also, the engine
data plate certifies that the engine conforms to
federal and any state
regulations. It gives the operating conditions
under which certification was made (Figure 1).
4.1.2 Transmission
The transmission identification plate is located
on the oil level dipstick side of the transmission
(WT) or on transmission (I-Shift) (Figure 2 &
Figure 3). The identification plate shows the
transmission serial
(assembly number), and model number. Use all
three numbers when ordering parts.

FIGURE 2: ALLISON TRANSMISSION

power steering pump
00052
exhaust emission
number, part number
07076