Battery Charging - Cube Controls FCORE User Manual

1.6 Battery Charging

As soon as the Q-CONN cable is connected, the device will automatically start the battery
charging process if needed.
Battery status led legend:
Green means the battery is fully charged.
Flashing yellow means the battery is at 5% capacity or less and needs charging.
Red means the battery is being charged.
Charging on the fly while in BLE mode is possible and the connection will be used only to
charge the battery without affecting the BLE communication. This is useful if the battery is low
during a race!
A full battery charge should take around 2 to 4 hours depending on the connection used. USB
3.0 ports or powered hubs are recommended as they allow the device to draw more power to
charge the battery.
Battery life will last approximately 50/60h. Battery level in % is also available from the Bluetooth
device list in the Windows "Bluetooth and other devices" page and also on the Device page of
the CubeSet App.
There can be a difference between the percentage shown on the Windows page and the
CubeSet App: in this case, keep in mind that the value on the Cube Set app is the correct one.