Lincoln Electric MOBIFLEX 200-M/HE Instruction Manual page 13

A-6
FIGURE A.7
A
C
See Figure A.8 for steps 7-8
7. Insert the clamping pin (A) through the hole in the
post located above the split pin.
8. Position the red plastic ring (B) and place the
clamping pin into the ridges (C). Rotating the red
plastic ring may be necessary.
FIGURE A.8
B
See Figure A.9 for steps 9-12
9. Turn the base swivel mount so, that the stop pin (A)
is in line with the cable lead-through hole (B).
10. Remove the wraping on the flexible hose.
11. Place the hose over the red plastic ring on the base
of the swivel mount. To secure the hose, at least
one metal ring of the hose should be applied over
the ridges at the red plastic ring.
12. Fold back the rubber seal and place it over the
hose. The underside of the rubber seal should
cover the red plastic ring 0.5-1 in.
MOBIFLEX 200-M(/HE) MOBILE FILTER UNIT & LFA 3.1 / 4.1 EXTRACTION UNIT
INSTALLATION
B
D
A
C
FIGURE A.9
LFA 3.1 / 4.1 MOBILE MANUAL
The supply cable inside the base swivel mount of the
Mobiflex 200-M(/HE) Base Unit is not used when
mounting a K2633-1 or K2633-3 LFA 3.1/4.1 Mobile
Manual arm.
Installation Steps:
ATTENTION
Do not remove the yellow tape
attaching both arm sections.
------------------------------------------------------------------------
ATTENTION
The supply cable inside the base
swivel mount should hang down
vertically. Do not remove the wire
bridge.
------------------------------------------------------------------------
See Figure A.10 for steps 1-2
1. Mount the extraction arm LFA 3.1/4.1 Mobile
Manual (A) on the post (B) using the two bolts M8
and two selflocking nuts M8 with washers.
2. Remove the yellow tape from both arm sections.
3. Proceed to Balance Check.
A-6
A
B