Midea MAP12S1TBL User Manual page 28

SET function
Press the SET button to enter the function setting, then press SET button
or TEMP or TEMP
symbol will flash on the display area, press the OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Sleep ( ) C SENSE (

[ ]: Model dependent.
*
C SENSE function (
The C SENSE function enables the remote control to measure the temperature at its
current location and send this signal to the air conditioner in 3 minute intervals.
When using AUTO, COOL or HEAT modes, measuring ambient temperature from the
remote control(instead of from the indoor unit itself) will enable the air conditioner to
optimize the temperature around you and ensure maximum comfort.
AP function (
Choose AP mode to do wireless network configuration. For some units, it doesn't work
by pressing the SET button. To enter the AP mode, continuously press the LED button
seven times in 10 seconds.
Sleep function(
The SLEEP function is used to decrease energy use while you sleep (and don't need
the same temperature settings to stay comfortable). This function can only be activated
via remote control. For the detail, Refer to the "Sleep Operation" section.
Note: The SLEEP function is not available in FAN or DRY mode.
Page 28
or
button to select the desired function. The selected

) AP mode(
) :
) (some units) :
) :
)
*