Operate The Autoprinter; 3 B I Nstall The Carousel; 4 B P Ower On And Off The Autoprinter - Rimage AutoPrinter User Manual

Operate the AutoPrinter

This section provides the information needed to operate your Rimage AutoPrinter.
I nstall the Carousel
1 3 B
J
Important! To prevent errors, install the carousel before operating the software or powering on the
AutoPrinter.
1. Slide the carousel into the AutoPrinter so
that the shaft slides into the opening of the
bearing guide. Refer to the
section on page 7 for proper carousel
placement.
2. Lower the carousel so that the top support
bearing drops into the bearing guide.
3. If necessary, rotate the carousel to seat the
carousel securely.
P ower On and Off the AutoPrinter
1 4 B
J
Important! The carousel must be installed before you power on the system. Refer to the
section above.
.
Notes:
·
The Prism printer has a separate power switch. The Prism power switch must be in the On position in
order for the printer to power on at the same time as the AutoPrinter.
·
The Everest printer does not have a power switch. The Everest printer powers on when the AutoPrinter
powers on. The Everest printer takes 1 to 2 minutes to complete initialization.
Ÿ
Press the power switch on the rear of the
AutoPrinter to the On position. The AutoPrinter
powers on.
Ÿ
Press the power switch to the Off position. The
AutoPrinter powers off.
110656_L
Bearing Guide
Front View
Shaft
Power Switch
Operate the AutoPrinter
Top Support Bearing
I nstall the Carousel
H H
9