Speciality Stitches; B13 Darning - ELNA eXcellence 770 Instruction Manual

z
e
x
r
e
q
w
c
r

Speciality Stitches

See pages 84 and 85 for referring sewing instructions of
B12 and B14.

B13 Darning

z Attach the automatic buttonhole foot R and pull the
button holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
q Button holder
w Starting point
x Start the machine and sew to the required length, then
press the reverse button. This sets the darning length.
Continue sewing until the machine stops automatically.
e Reverse button
r Required length
c Sew another layer of darning over the first layer, at a
right angle to it.
NOTE:
The maximum darning length is 2 cm (3/4˝) and the
maximum width is 0.9 cm (3/8˝).
To sew the same size darning
When finished sewing, a confirmation message will
appear.
Simply start the machine to sew another layer of darning
stitches in the same size.
To sew the next layer of darning stitches in a different
size, press the X key.
To sew a shorter darning
Sew the first line to the desired length and stop the
r
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
pressing the "–" or "+" key of the adjusting window.
If the left corner is lower than the right side, press the
"–" key to correct it.
If the right corner is lower than the left side, press the
"+" key to correct it.
50