Winding The Bobbin; Bobbin Winding With The Extra Spool Pin - ELNA eXperience 450 Instruction Manual

z q
x c
v
b
n m
w

Winding the bobbin

NOTE:
Set the speed control slider at its fastest position for
bobbin winding.
z Hold the thread with both hands and guide the thread
w
x Thread through the hole in the bobbin from the inside
c Put the bobbin on the bobbin winder spindle.
v Push the bobbin winder spindle to the right.
e
b With the free end of the thread held in your hand, start
n Start the machine. When the bobbin is fully wound, it
m Remove the bobbin. Cut the thread as shown.
NOTE:
• Do not move the bobbin winder spindle while the
• For safety purposes, the machine will automatically

Bobbin winding with the extra spool pin

Draw the thread from the spool and pass the thread
around the bobbin winding tension disk as shown.
Start the procedure from x above.
w Bobbin winder tension disk
16
from back to front under the upper thread guide.
q Upper thread guide
Guide the thread into the bobbin winder tension disk
as illustrated.
w Bobbin winder tension disk
to the outside.
The bobbin mark appears on the LCD display.
e Bobbin mark
the machine. Stop the machine when it has wound a
few layers, and then cut the thread close to the hole in
the bobbin.
will stop spinning automatically.
Stop the machine and return the bobbin winder to its
original position by moving the spindle to the left.
Return the speed control slider position.
machine is running.
stop 90 seconds after starting bobbin winding.