Commissioning - FERREX CSP50 User Manual

Before commissioning/Commissioning Symbole
• Pour the chain oil into the chain oil tank. Do not spill chain oil when refuelling and do not
fill the chain oil tank to the brim.
• Wipe up spilled chain oil immediately.
• Turn the chain oil tank cap (14) clockwise to close it.
8.5 Tensioning and checking the saw chain
m WARNING
Put on protective gloves! Danger of injury due to the sharp cutting teeth!
Check the chain tension regularly before each start-up.
• Before tensioning, loosen the two fixing nuts (20) a little with the spark plug wrench /
slotted screwdriver (28).
• Turn the chain tensioning screw (21) clockwise with the spark plug wrench / slotted
screwdriver (28) to increase the tension.
• Tighten the two fixing nuts (20) with the spark plug wrench / slotted screwdriver (28).
• The saw chain (17) must be in contact with the underside of the guide bar. Check whether
the saw chain (17) can be pulled over the guide bar (16) by hand (with the chain brake
released, pull the front hand guard (1) back).
NOTE
A new saw chain (17) stretches and needs to be retensioned more often.

9. Commissioning

m CAUTION
Please observe the legal provisions from the noise protection ordinance.
Before each start-up, check the device for the following:
• Check the fuel system for leakage
• Faultless condition and completeness of the guards and the cutting device
• Tight fit of all screw connections
• Smooth running of all moving parts
Working instructions
Familiarise yourself with handling the chainsaw before use.
24