Ml-Ser Tool; Connecting Ml-Ser Tool To The Device; Ml-Ser Menu - Produal HDK User Manual

If the automatic calibration function is not in use, the device should be calibrated every 6-12 months.
The recommended calibration interval is 5 years even if the automatic calibration is in use.

1.4 ML-SER tool

1.4.1 Connecting ML-SER tool to the device

1. Open the cover.
2. Disconnect the display cable.
3. Connect the ML-SER cable to the display connector.
A. Display connector

1.4.2 ML-SER menu

ML-SER menu opens by pressing the M button. The values can be changed with the "+" and "-"
buttons. The menu is device-specific and the content depends on the device and installed options.
The following menu structure contains the factory settings.
Note: The default relay CO
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 28.08.2019
G
G0
Y1
PWR
Y2
RX
Y3
TX
Y4
REL
A A+
B-
BUS
NO
TERM
NC
set point is 2500 ppm in 10K models.
2
Information is subject to change without prior notice.
4 (15)
EN - 1135050ug