Elation PIXEL WASH 40IP User Manual page 7

S A F E T Y G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation. Disconnect from power and allow
approximately 15 minutes for the fixture to cool down before servicing.
• DO NOT shake fixture, and avoid using brute force when installing and/or operating the
fixture.
• DO NOT operate the fixture if the power cord is frayed, crimped, damaged, and/or if any of
the power cord connectors are damaged and do not plug into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its
connectors are damaged, replace it immediately with a new one of the same power rating.
• DO NOT block any air ventilation slots.
• All fan and air inlets must remain clean and never blocked.
• Leave approx. 6" (15cm) between the fixture and other devices or a wall in order to allow
for proper cooling.
• When installing fixture in a suspended environment, always use mounting hardware that
is no less than M10 x 25 mm, and always install fixture with an appropriately rated safety
cable.
• Always disconnect the fixture from the main power source before performing any type of
service and/or cleaning procedure.
• Only handle the power cord by the plug end. Never pull out the plug by tugging on the wire
portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the interior
of the fixture. This is a normal process and is caused by excess paint in the interior of the
casing burning off from the heat associated with the lamp. This will decrease gradually over
time.
• Consistent operational breaks will ensure fixture will function properly for many years.
• ONLY use the original packaging and materials to transport the fixture for service.
7