Address Tables; Device Data; Operating Level Parameters - JUMO IPC 300 Operating Manual

5

Address tables

The following tables in this chapter list the addresses of the readable and writable words. SCADA pro-
grams, PLCs, or similar can be used to read and/or write the values.
The entries under "Access" mean the following:
R
R/W
The number of characters stated under "Data type" for character strings includes the final '\0'.
Example: "text (10 bytes)" means that the text is up to 9 characters long. The end flag '\0' is then added.
5.1

Device data

5.1.1 ID
Address
0x0000
0x0006
0x000D
0x000E
0x0013
0x001D
0x0023
0x0024
0x0025
0x0026
0x0027
0x0037
0x0038
0x0039
0x003A
0x003B
...
0x0096
5.1.2

Operating level parameters

The following parameters are applied in the RAM when writing data. This means they can be re-written
cyclically, but are lost when the device is switched off.
Address
0x0097
Read Only, value can only be read
Read/Write, value can be written and read
Access Data type
R text (11 bytes) Software version
R text (13 bytes) VdN number
R word (16 bits) Internal software version
R text (9 bytes) Device name ("IPC 300")
R text (20 bytes) Fabrication number
R text (9 bytes) Inspection ID
R word (16 bits) Reserve
R word (16 bits) Reserve
R word (16 bits) Reserve
R word (16 bits) Reserve
R text (31 bytes) Order code
R enum
R enum
R enum
R enum
R word (16 bits) Reserve
R word (16 bits) Reserve
R word (16 bits) Reserve
Access Data type
R, W enum
Signal designation
Basic type:
0 = IPC300_709051
Nominal current:
0 = 70 A,
1 = 100 A
2 = 200 A
Equipped digital output:
0 = Relay
1 = Optocoupler
Equipped interface:
0 = None
1 = RS422/485
2 = PROFINET
Signal designation
Language
5 Address tables
17