Vega Si-13" Tab - Vega Absolute Vega SI-13 User Manual

"VEGA SI-13" TAB

The "Vega SI-13" tab contains the settings of the connected device.
Current state – displays the current parameters of the device - the number of counted
pulses at the inputs and the temperature.
To reset the collected readings from device memory, it is necessary to put the device
in the "Storage" mode by pressing the button on the board for a long time (more than 5
seconds) (see section "Initial startup").
Input settings – allow you to change the operation of the pulse inputs from the
counting of pulses to the security mode and back. When transferring the input to the security
mode, the device will send an alarm packet to the network (See part 5, packet 2) whenever
22
Vega SI-13 / User Manual
Revision 13 - 23 September
2020