Vega Absolute Vega SI-13 User Manual page 19

Vega SI-13 / User Manual
This frequency band allows you to set up to 16 channels, as well as the frequency and
speed of the second receiving window.
The first three channels and the second receiving window
parameters are mandatory. Without these parameters the custom
frequency band will be considered empty
Activation type – selecting ABP or OTAA device activation method.
Confirmed uplinks – when you choose "confirmed", the device will retry sending the
packet until it receives the server confirmation, or until the "Uplink number of transmission" is
over (see below).
ADR – this option activates the Adaptive Data Rate algorithm for automatic control of
the data transfer rate from the LoRaWAN network side. The higher the quality of the signal
received by the network, the higher the speed will be installed on the device. This option is
recommended only on permanently installed devices.
RX1 offset (not displayed in the "Simple" mode) – specifies the time between end of
packet transmission and first receiving window opening. The second receiving window
always opens after 1 second after the first.
Revision 13 - 23 September
2020
19