What To Do If - Zanussi ZCG560N User Manual

3
2
2
5
Use a spatula
made of wood or
plastic or equivalent
to open the inner
door.
Hold the outer door,
and push the inner
door against the top
edge of the door.
Warning! Only clean the glass panel with
water and a soap. Abrasive cleaning
agents, stain removers and sharp objects (e.g.
knives or scrapers) can cause damage to the
glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, in-
sert the oven door. To do so, do the steps in
opposite way.
4
4
6
5
5

What to do if...

Problem
There is no spark when light-
ing the gas
There is no spark when light-
ing the gas
www.zanussi.com
6
Lift the inner door.
7
Clean inner side
of the door.
Clean the glass panel
with water and soap.
Dry it carefully.
Possible cause
There is no electrical supply
There is no electrical supply
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of electrical
shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at the
back of the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with an applicable
300 °C heat-resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
Make sure that the unit is connected and the
electrical supply is switched on.
Examine the house electrical installation
fuse.
Remedy
13