Link Aggregation - Cerio CS-2208G-8PA2 User Manual

8. Link Aggregation

The function supports 802.3ad LACP, Link Aggregation Control Protocol.
Link Aggregation Control Protocol (LACP) can aggregate multiple Ethernet ports together to
form a logical aggregation group. To upper layer entities, all the physical links in an
aggregation group are a single logical link.
LACP Global State: Administrator can Enable/Disable the function. To "Enable" the

function, the previous settings of the ports of the same group must be set in the same
way.
Link Aggregation Algorithm: Administrator can select SA or DA or SA+DA for the

MAC Frame.
MAC DA: Destination Address
MAC SA: Source Address
Layer2 Packet Frame : The following example
Preamble
Link Group Activity: Administrator can select "Active" or "Passive" of the "Link

Group Activity."
To properly use LACP, the two switches must have one switch enable
"Active" function or both enable "Active", Administrator cannot set
"Passive" in the two switches.
Link Group Member: If LACP function is enabled, the Link Group member will be

auto-displayed. In this model, Port 7 & 8, and Port 9 & 10 are set as groups.
V2.0b
SFD DA SA Ether type Payload ........