Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
fizzing, hissing
loud.
46
Cause and Troubleshooting
Load recognition is active.
No error, no action necessary.
▶
Remark:The load detection can take up to 2 minutes.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
Advertisement
Table of Contents
