Table of Contents
Advertisement
Malfunction
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum jerks after
program start.
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the spin
run.
Cause and Troubleshooting
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system provides an extra rinse when
foaming is too high.
No error - no action required.
▶
The water is below visible range.
No error - no action required.
▶
▶ Do not fill the device with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
Insert in compartment is hidden.
→ "Cleaning the detergent drawer", Page
▶
35
The appliance is not leveled properly.
→ "Adjusting the device", Page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 16
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
TroubleshootingNL
45
Advertisement
Table of Contents
