Table of Contents
Advertisement
NLCleaning and maintenance
As there may still be residual
1.
water in the pump, carefully
unscrew the lid.
Large impurities can cause the
s
filter element to get stuck in the
pump housing. Loosen impurities
and remove filter element.
Clean the interior, screw thread of
2.
the pump cover and pump
housing.
The pump cover consists of two
components that can be
disassembled for cleaning.
Verify that the pump impeller rotates
3.
easily.
38
Install the pump cover.
4.
Check that the pump cover
s
components are correctly
assembled.
Tighten the pump cover as far as
5.
it will go.
90°
The pump cover handle must
be vertical.
Before the next wash
To prevent unused detergent from
flowing into the drain during the next
wash, run a suitable draining program
after emptying the pump.
Open the water tap.
1.
Plug in the mains plug.
2.
Switch on the device.
3.
Pour one liter of water into
4.
compartment II.
Advertisement
Table of Contents
